Viewing 15 posts - 16,936 through 16,950 (of 39,831 total)
You likely need something like this:
From Orders o
Inner Join OrderDetails od
ON o.orderid = od.orderid
Inner Join Products p
on...
January 20, 2011 at 10:30 am
New forum for speakers. Critique abstracts and titles. I would love the feedback from people that actually go to sessions and try to decide what's good and bad.
January 20, 2011 at 10:19 am
Stefan Krzywicki (1/20/2011)
My favorite was one that wanted 5+ years experience in VB.Net in 2001.
I think that I saw that job as well. Saw a few similar ones asking for...
January 20, 2011 at 10:08 am
SanDroid (1/20/2011)
The question was the types of restore supported, not the restore commands supported. Wording is everyting in...
January 20, 2011 at 9:39 am
New people find the QOD every day, so it's not always easy. I should have scheduled this one a few weeks later to see if you remembered 😉
January 20, 2011 at 9:37 am
I believe I learned the formula applies to both extensions and initial builds.
January 19, 2011 at 8:58 am
Good question, I would lean towards W2K8, but if probably both would be good. Likely to be W2K3 for some time out there.
January 19, 2011 at 8:58 am
Hugo Kornelis (1/19/2011)
Thanks, Gail.So apparently, the documentation is not incomplete, it just hides it's completeness very well 😉
I think more that it's poorly written. I miss the "submit a note"...
January 19, 2011 at 8:36 am
32 bit programs should not, in general, have issues on x64 if they run standalone (not drivers). Glad that wasn't an issue here. Thanks for the update.
January 19, 2011 at 8:28 am
jcrawf02 (1/18/2011)
Hey, where did the list of SQL Spackle article ideas get to? Can't find it by searching on the forums, unless I just suck.
Some are spackley, some are just...
January 18, 2011 at 7:01 pm
djackson 22568 (1/18/2011)
In short, I set the bar above, not below, my audience, and I find that the people I support tend to become self sufficient much sooner than others.
Well...
January 18, 2011 at 6:59 pm
I don't see these as holes in SSIS, but more potential holes in process using SSIS.
January 18, 2011 at 6:06 pm
Viewing 15 posts - 16,936 through 16,950 (of 39,831 total)