Viewing 15 posts - 946 through 960 (of 3,666 total)
Ed Wagner (9/29/2014)
Koen Verbeeck (9/29/2014)
Went over 13,000 points today. Seems like a déjà vu 😀 😎
Yeah, hopefully the root cause of the problem is found and corrected soon. In...
September 29, 2014 at 7:51 am
Koen Verbeeck (9/29/2014)
Hire an overpriced consultant. Chances are they'll listen to him/her...
If you happen to follow this route, be sure to provide management your recommendation before the consultant starts.
September 29, 2014 at 7:47 am
What issues are you experiencing with importing from Excel?
Unless you are correcting data as it moves from Excel to Access, I cannot think of any reason why you could not...
September 26, 2014 at 10:56 am
Eirikur Eiriksson (9/25/2014)
Alvin Ramard (9/25/2014)
Eirikur Eiriksson (9/25/2014)
Alvin Ramard (9/25/2014)
Eirikur Eiriksson (9/25/2014)
SQLRNNR (9/25/2014)
Lynn Pettis (9/25/2014)
Sean Lange (9/25/2014)
September 25, 2014 at 4:00 pm
Eirikur Eiriksson (9/25/2014)
Alvin Ramard (9/25/2014)
Eirikur Eiriksson (9/25/2014)
SQLRNNR (9/25/2014)
Lynn Pettis (9/25/2014)
Sean Lange (9/25/2014)
September 25, 2014 at 3:20 pm
Eirikur Eiriksson (9/25/2014)
SQLRNNR (9/25/2014)
Lynn Pettis (9/25/2014)
Sean Lange (9/25/2014)
September 25, 2014 at 3:00 pm
His excessive posting has been reported.
September 25, 2014 at 2:37 pm
My answer to a number of these questions would start with: "Well that depends. Can you elaborate on what you mean by ..."
Some questions are rather vague, just like the...
September 25, 2014 at 12:32 pm
Steve Jones - SSC Editor (9/23/2014)
GilaMonster (9/23/2014)
Koen Verbeeck (9/23/2014)
There is a sync job for the points, so I think we'll get our points back in a matter of time.
That job...
September 23, 2014 at 8:52 am
I'm down a fair number of points too and I did not post during the affected time period, so, it does look like there's a problem somewhere else.
September 23, 2014 at 8:40 am
It's hard to comment without seeing the whole process. It does seem like a large number to be inserting into a temp table, but if done correctly, it may...
September 23, 2014 at 7:59 am
Stefan Krzywicki (9/22/2014)
September 22, 2014 at 2:29 pm
SQLRNNR (9/22/2014)
Eirikur Eiriksson (9/22/2014)
Steve Jones - SSC Editor (9/22/2014)
Eirikur Eiriksson (9/22/2014)
Steve Jones - SSC Editor (9/22/2014)
It's backHandful of posts missing, did you break the log chain;-)
😎
There was no chance to...
September 22, 2014 at 11:36 am
Steve Jones - SSC Editor (9/22/2014)
Biml
BIML = Biml I Must Learn 🙂
September 22, 2014 at 10:10 am
Don't know if SSIS is the best choice, but I would be my preferred choice.
SSIS gives you lots of options to do want you want, and it's graphical interface often...
September 22, 2014 at 9:18 am
Viewing 15 posts - 946 through 960 (of 3,666 total)