Post reply

Perfmon stupid question

  • April 16, 2010 at 8:31 am

    #231860

    Hi all

    I have run a counter to monitor IO on my disks and used the Avg. Disk sec/Read and write counters. I have now stopped these counters and am looking at the graphs. I have my scale set to 0 to 1 but I can't see in the minimum, maximum and avergae fields what the accurate values are as it doesn't go to any decimal places.

    In other word all it is telling me is that the Min was 0 and the Max was 1. How can I increase the decimal places, its driving me potty.

    Thanks

  • April 16, 2010 at 8:51 am

    #1152896

    Ok I have found the scale drop down in the data tab, but still it doesn't change the mi, max and avg fields to anything other than to 0 or 1 i.e. no decimal places.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic. Login to reply