thx steve, yes i always go to advanced with things like this.  in this case, in the final oledb destination, i change the data type in advanced and ssis ignores...

• This reply was modified 3 weeks, 4 days ago by stan.

this gets better and better.   we see the same values on another vm's config  where there is no issue with processing full an ssas db.   we also see the problematic...

i believe this is the problem.   Does the community know what causes these values to be set to 1?   Is that perhaps the default nowadays?   I dont see them even...

• This reply was modified 3 weeks, 4 days ago by stan.

tried following the instructions shown below , thru powershell, to determine if certain known registry settings might have been set but basically the error thrown was that there is no...

may have to open a ticket with MS.   will post back here what, if anything, that i find out.