Just wondering if anyone has used the new SNAPSHOT isolation level in SQL 2005 yet, and if anyone has any comments on it's potential as a replacement for nolock/READ UNCOMMITTED.
From BOL: SET TRANSACTION ISOLATION LEVEL (Transact-SQL)
Specifies that data read by any statement in a transaction will be the transactionally consistent version of the data that existed at the start of the transaction. The transaction can only recognize data modifications that were committed before the start of the transaction. Data modifications made by other transactions after the start of the current transaction are not visible to statements executing in the current transaction. The effect is as if the statements in a transaction get a snapshot of the committed data as it existed at the start of the transaction.
Except when a database is being recovered, SNAPSHOT transactions do not request locks when reading data. SNAPSHOT transactions reading data do not block other transactions from writing data. Transactions writing data do not block SNAPSHOT transactions from reading data.
During the roll-back phase of a database recovery, SNAPSHOT transactions will request a lock if an attempt is made to read data that is locked by another transaction that is being rolled back. The SNAPSHOT transaction is blocked until that transaction has been rolled back. The lock is released immediately after it has been granted.
The ALLOW_SNAPSHOT_ISOLATION database option must be set to ON before you can start a transaction that uses the SNAPSHOT isolation level. If a transaction using the SNAPSHOT isolation level accesses data in multiple databases, ALLOW_SNAPSHOT_ISOLATION must be set to ON in each database.
A transaction cannot be set to SNAPSHOT isolation level that started with another isolation level; doing so will cause the transaction to abort. If a transaction starts in the SNAPSHOT isolation level, you can change it to another isolation level and then back to SNAPSHOT. A transaction starts at the BEGIN TRANSACTION statement.
A transaction running under SNAPSHOT isolation level can view changes made by that transaction. For example, if the transaction performs an UPDATE on a table and then issues a SELECT statement against the same table, the modified data will be included in the result set.