Click here to monitor SSC
SQLServerCentral is supported by Red Gate Software Ltd.
 
Log in  ::  Register  ::  Not logged in
 
 
 

SQLAndy

I'm Andy Warren, currently a SQL Server trainer with End to End Training. Over the past few years I've been a developer, DBA, and IT Director. I was one of the original founders of SQLServerCentral.com and helped grow that community from zero to about 300k members before deciding to move on to other ventures.

First Try at a Wooden Hand Plane

I’ve been reading about wooden hand planes lately (as opposed to hand planes made of metal that plane wood) and decided to just do a quick experiment to see what I thought.

I started with a square piece of rosewood about 2” thick, ripped a piece 2.5” wide, then ripped 1/4” slab from each side. That leaves the center piece which gets cut into half to create the two bevels you see in the center below. Then you glue it all back together. It’s a quick way to remove all the wood from the center.

The four pins you can see are 1/16” brass rod. It’s just what I had on the shelf. I cut them long and then used my 6” grinder to flush them to the wood. The center pin is a 1/4” oak dowel. The plane blade is from a $5 cheapie plane from Harbor Freight and the wooden wedge on top of it is cut from the scrap from the center.

I didn’t fuss over it, you can see the blade marks and I just eyeballed the pin placement. For a very fast first try I like it, tomorrow I’ve got to widen the mouth where the blade sticks out, too tight right now to take a good shaving. Then we’ll see.

HandPlane1a

 

HandPlane1b

Comments

Leave a comment on the original post [www.sqlandy.com, opens in a new window]

Loading comments...